The Intel Assabet (SA-1110 evaluation) board
============================================

Please see:
http://developer.intel.com/design/strong/quicklist/eval-plat/sa-1110.htm
http://developer.intel.com/design/strong/guides/278278.htm

Also some notes from John G Dorsey <jd5q@andrew.cmu.edu>:
http://www.cs.cmu.edu/~wearable/software/assabet.html


To build the kernel:

	make assabet_config
	make config
	[accept all defaults]
	make dep
	make zImage

Typically, you'll need angelboot to load the kernel.
The following angelboot.opt file should be used:

----- begin angelboot.opt -----
base 0xc0008000
entry 0xc0008000
r0 0x00000000
r1 0x00000019
device /dev/ttyS1
options "9600 8N1"
baud 115200
otherfile ramdisk_img.gz
otherbase 0xc0800000
exec minicom
----- end angelboot.opt -----

Then load the kernel and ramdisk with:

	angelboot -f angelboot.opt zImage

Here it is assumed that your Assabet is connected to ttyS1 and that
minicom is preconfigured with /dev/ttyS1, 9600 baud, 8N1, no flow control
by default.

This is work in progress...

Please send any patches to nico@cam.org.